This document describes the installation and setup of the TCP/IP
stack in Windows NT 4.0 to connect with Infintiy AccessNet. Follow the
instructions below to run the Dial-Up Networking Wizard and configure
your connection.
1. Double-click on the My Computer icon and double-click
on Dial-Up Networking.
When prompted for a new phonebook entry, click Ok. If the
Wizard does not start, click the New button.
2. New Phonebook Entry Wizard: Name the new entry Infinity
and click Next.
3. Server: Check both I am calling the Internet and The
non-Windows NT server I am calling expects me to type login information
after connecting, or to know TCP/IP addresses before dialing. Then
click Next.
4. Phone Number: Enter your local access number. The access number
for Infinity AccessNet is 952-253-5324
Once you have entered your phone number click Next.
5. Serial Line Protocol: Check Point-to-Point Protocol [PPP] and
click Next.
6. Login Script: Choose Automate With This Script.
Choose Generic Login.
Click Next
7. IP Address: Leave the IP address entry as 0.0.0.0 or server assigned
IP address and click Next.
8. Name Server Addresses
For the DNS server entry type 209.134.128.1
Leave the WINS server entry as 0.0.0.0
Click Next.
9. New Phonebook Entry Wizard: Click Finish to save your settings.
10. Dial-Up Networking: Check that the entries you made are correct
and click Dial.
11. Connect to Infinity: Enter an upper case "P" followed
by the Username we gave you in all lower case under User name:
Enter the Password we gave you in all lower case under Password:
Click OK
12. Put the Infinity Dialup Networking Icon on your desktop by double
clicking on the Dial-Up Networking Icon and choosing your Infinity AccessNet
configuration.
Now click the More button and choose Creat Short Cut to Entry.
[You can also edit your connection information at any time by clicking
the More button and the Edit Entry option.]
Revised 3/6/00